No dazzling strong light
The LED light is composite resin sensitive blue light, not
dazzling, therefore doctors can observe the curing position more
clearly, and improve quality of operating. But the Halogen light
only has little part which is blue light, and still has much
useless non-blue light coming into the light spot even after
filtered, which makes the light spot extremely dazzling,
therefore you must use light-hiding slide, this will influence
doctor observation in operation, And these useless non-blue
light can transform into heat energy through resin, make some
part turn into high temperature, which may burn dental marrow,
and has the bad side effect such as toothache.
No noise and no vibration
LED hardly generate heat and does not need to dispel the heat
with the annoying fan, there are no noise and vibration. To the
doctors and patients, especially child patients, it is extremely
comfortable.
Low maintenance expense
LED has a very long life-span (for more than ten thousand
hours), but the life-span of general halogen lamp is only about
40-50 hours, with great cost and trouble of replacing a new
lamp. The LED has very low power consumption, about 3 watts, but
the general halogen lamp takes 75-100 watts.
Two-level light intensity design
Firstly penetrate with the weak illumination, and then use
intensive light for fast solidification. This can suppress resin
superficial shrinking too fast, prevent cracking between resin
and tooth-hole edge.
Large capacity battery
Using 750 mAh rechargeable battery, each charge can use more
than 60 times X 40 seconds.
Technical characteristics
• Battery: rechargeable Ni-H battery 4.8V 750 mAh
• Spectrum range: 440nm-490nm
• Operation time: weak light: 0s-9s(interval 1 second) intense
light: 0s-60s (interval 10 seconds)
• Turbo light guide: light inlet : f 12.8mm ± 0.4mm light
outlet: f 7.6 mm ± 0.4mm
• Depth of solidifying resin for 40s intense light: no less
than 3mm
• Automatically shut down time: 3 min ± 20s
• Power source: AC 220 V (OR 110V) frequency: 50 / 60 Hz
